Setting Procedures And Modes - Panasonic LightPix AE20 User Manual

4.2.3 Setting Procedures and Modes

The LightPixAE20 can be configured following the steps below:
1 Set up devices.
2 Turn the LightPixAE20 on.
Configure the
3
LightPixAE20.
(in CONFIGURATION mode)
Run teaching.
4
(in TEACHING mode)
Set judgement criteria
5
(in JUDGEMENT CRITERIA
SETTING mode).
Execute an inspection
6
(in RUN / RUNVIEW mode)
There are four modes available for the LightPixAE20. The settings that you can make vary depending on the
mode. To switch the modes, follow the instructions below.
34
Install the main unit and connect to a power supply unit,
each unit and external devices.
Apply 24 V DC
Set up the LightPixAE20 system in CONFIGURATION
mode.
Inspection/communication conditions and hardware settings
of the unit
In the TEACHING mode, register extraction color, at the
same time, set the exposure time or range for measuring
area (inspection area), and area for setting extraction color.
In JUDGEMENT CRITERIA SETTING mode, set the limits
of area values (min. to max.). If the area values are within
the limit, the LightPixAE20 judges as OK.
Press the TRIGGER button in RUN (RUN VIEW) mode.
Section 3
-
Page 35
Page 37
Page 41
Page 42