HP StoreOnce User Manual page 49

Table 13 Source Appliances parameters
Serial Number
Appliance Name
Appliance Status
Appliance Address
Configured Mappings
3. Click Add. A wizard guides you through the necessary steps to add a new source appliance
to the list. You will need to provide the serial number of the appliance and can also specify
initial access permissions for all libraries and all shares on that appliance.
4. Once the appliance has been added to the list of Source Appliances, permissions can be
configured for it.
To configure permissions (administrators only)
1. Select the source appliance in the list. There are two tabs; one for Libraries and one for Shares.
2. Click Edit. You can now check the Access box for those shares and libraries to which access
should be granted. These are the shares and libraries that will be displayed when the mapping
configuration step is run in the Replication wizard. It will not be possible to create a new share
or library from the wizard.
3. Click Update to apply the permissions.
This is the serial number for the required service set. This information can be found
on the top-level HP StoreOnce page.
This is the name of the appliance for which you have specified the serial number and
cannot be altered.
This is the status of the appliance for which you have specified the serial number and
cannot be altered.
This is the address of the appliance for which you have specified the serial number
and cannot be altered.
This checkbox indicates whether any mappings have been configured on the source
appliance. This is important to know, because any mappings that already exist will
be retained regardless of any access permissions you subsequently set up for libraries
and shares on that appliance.
Partner Appliances (Replication) 49