Bus Address Settings - Bosch B450 Installation & Operation Manual

8 en | System overview
B450 module overview
1
10
Figure 3.1: B450 Plug-in Communicator Interface
Callout ￚ Description
1 ￚ Tamper switch connector
2 ￚ Bus address switch
3 ￚ MODE 2-pin jumper connector (for future use)
4 ￚ Bus address label
5 ￚ USB connector (Type A)
6 ￚ Heartbeat LED
7 ￚ RX LED (indicates packets received from the wireless network)
8 ￚ TX LED (indicates packets transmitted over the wireless network)
9 ￚ Terminal strip (to control panel)
10 ￚ Interconnect wiring connectors (to control panel or other compatible modules)
3.2

Bus address settings

The address switch determines the bus address for the B450 Conettix Plug-in Communicator
Interface. The control panel uses the address for communications. Use a slotted screwdriver
to set the address switch.
Notice!
The B450 reads the bus address switch setting only during power up. If you change the
switch after you apply power to the module, you must cycle the power to the module in order
for the new bus address setting to be used for bus communication.
2013.09 | 02 | F.01U.282.875
9
TX RX
8
7
Installation and Operation Guide
6
5 4
Conettix Plug-in Communicator
2
3
Bosch Security Systems, Inc.
Interface