Use Usb To Configure The B450 - Bosch B450 Installation & Operation Manual

22 en | Configuration
Figure 5.4: B450 status as shown as Ethernet Communicator in RPS Diagnostics with GV4 version 2.00
5.3

Use USB to configure the B450

You can use a USB connection from a laptop PC to the B450 to configure the B450 on-site.
The supported USB cable used to establish connection is a Type A to A, male-to-male cable.
Notice!
USB connection via the USB cable is used for temporary configuration programming only.
Before you can access the USB user interface, you must install the RBUS1CP.inf file, and USB
driver on the target PC or laptop. The RBUS1CP.inf file and USB driver are available on the
supplied CD‑ROM. You need to install this file only once on the target PC or laptop.
If the B450 CD-ROM is not available:
1.
2.
3.
4.
5.
6.
7.
8.
2013.09 | 02 | F.01U.282.875
From your Internet browser, go to: http://www.boschsecurity.com to open the Bosch
Web site.
Select the web site for your region and country.
In the Online Catalogs section on the left, click the Intrusion Alarm Systems link.
Under the Intrusion Alarm Systems Products heading, scroll to the Conettix -
Information Transport Solutions section. Click the Show product section link.
Click the Conettix IP link.
Scroll to the B450 Plug-in Communicator Interface section. Click the section title to
open the product page.
Under the product image, click the Software tab.
Click OK to accept the license agreement.
Installation and Operation Guide
Conettix Plug-in Communicator
Interface
Bosch Security Systems, Inc.