Introduction; About Documentation; Bosch Security Systems, Inc. Product Manufacturing Dates; Installation Workflow - Bosch B450 Installation & Operation Manual

Conettix Plug-in Communicator
Interface
2

Introduction

2.1

About documentation

Copyright
This document is the intellectual property of Bosch Security Systems, Inc. and is protected by
copyright. All rights reserved.
Trademarks
All hardware and software product names used in this document are likely to be registered
trademarks and must be treated accordingly.
2.2

Bosch Security Systems, Inc. product manufacturing dates

Use the serial number located on the product label and refer to the Bosch Security Systems,
Inc. website at http://www.boschsecurity.com/datecodes/.
The following image shows an example of a product label and highlights where to find the
manufacturing date within the serial number.
2.3

Installation workflow

To install and configure the device, use the workflow below and follow in sequential order
from top to bottom, marking off each box as you complete a step.
Caution!
Always power down the control panel when connecting the B450. Power down the control
!
panel by unplugging the transformer and disconnecting the battery.
configure the module to work with a compatible control panel. Refer to Setting the bus
address, page 10)
communication module (required and available separately), page 10)
Bosch Security Systems, Inc.
Plan the installation of the B450 Conettix Plug-in Communicator Interface
Unpack the device contents
Power down the system
Select the bus address value for the compatible control panel (This will automatically
Insert the desired plug-in communicator into the B450 (Refer to Insert the B44x
Mount the B450 into the enclosure (Refer to Mount the module in the enclosure, page 11)
Wire the B450 to a compatible control panel (Refer to Wire to the control panel, page 13)
Power up the system
Installation and Operation Guide
Introduction | en 5
2013.09 | 02 | F.01U.282.875