Wire To The Control Panel - Bosch B450 Installation & Operation Manual

Conettix Plug-in Communicator
Interface
1.
Notice!
If you are experiencing a weak signal, place the antenna on top of a metal surface that has a
radius of 10.16 cm (4 in) for optimal performance.
2.
3.
4.
Figure 4.4: Antenna installation
Callout ᅳ Description
1 ᅳ B44x plug-in cellular communicator antenna (routed through any knock-out)
2 ᅳB44x plug-in cellular communicator antenna cable (connected to the module)
4.5

Wire to the control panel

When you wire a B450 to an SDI, or SDI2 control panel, you can use either the module's
terminal strip labeled R, Y, G, B (PWR, A, B, COM) or the module's interconnect wiring
connectors (wire included). The figure below indicates the location of both the terminal strip
and the interconnect wiring connectors on the module.
Bosch Security Systems, Inc.
Place the magnetic antenna on top of the enclosure, or vertically on another metal
surface.
Route the antenna cable through a knock-out in the enclosure wall.
Connect the antenna cable to the module.
Secure the antenna cable to the inside of the enclosure.
Installation and Operation Guide
1
Installation | en 13
2
2013.09 | 02 | F.01U.282.875