Short Message Service (Sms) Configuration; Use Sms To Configure The B450 - Bosch B450 Installation & Operation Manual

32 en | Configuration
ID Parameter
20 SMS Configuration
65 IPv4 DNS Server IP
Address
66 Alternate IPv4 DNS
Server IP Address
67 Panel Programming
Enabled
68 Reporting Delay for
Low Signal
Strength
69 Reporting Delay for
No Towers
70 Reporting Delay for
Single Tower
71 Modem Reset
Count
72 TCP Keep Alive
Time
Table 5.5: SMS and USB configuration parameters
5.4

Short Message Service (SMS) configuration

The B450 supports configuration by SMS connection. The Short Message Service feature
allows an installer to configure the B450 through the use of a mobile phone, or any other
service that sends compatible SMS text messages.
5.4.1

Use SMS to configure the B450

The SMS string follows a specific format. If the configuration message exceeds 160
characters, you must send multiple messages. Refer to Compose the Configuration SMS for
more details.
When the B450 receives the final valid part of an SMS message, it accepts the configuration.
2013.09 | 02 | F.01U.282.875
Values
0 = Disabled
1 = Enabled
IPv4 address format (0.0.0.0)
IPv4 address format (0.0.0.0)
0 = Disabled
1 = Enabled
0 – 3600 sec. (1800)
0 – 3600 sec. (1800)
0 – 3600 sec. (0)
0 – 99 communication attempts
(5)
0 – 255 sec (45)
Installation and Operation Guide
Description
Allows the B450 to be configured via SMS
configuration.
The B450 uses the DNS server addresses supplied
by the cellular network when the Primary DNS
Server address option is configured as 0.0.0.0. If
the address is not configured as 0.0.0.0, the B450
installs the Primary DNS Server address.
If the address is not configured at 0.0.0.0, the B450
installs the Alternate DNS Server address.
Select to enable or disable control panel
programming. This enables/disabled configuration
of the B450 by the control panel.
Sets the duration of time when the B450's signal
strength is measured. The value selected
determines how long the signal strength must be at
a low condition before reporting as low, or how
long the signal strength must be normal before
reporting as normal.
Amount of delay before the module reports a
trouble for not being able to receive signals from a
cell tower.
Amount of time delay before module reports a
trouble due to getting signals from only one tower
instead of multiple towers.
This parameter determines how many times a
packet of data must be sent without a reply before
the cell module modem is reset to attempt
restoring communications.
This parameter determines how long to wait
between transmissions to keep an idle TCP
connection to a remote host from terminating due
to inactivity.
Conettix Plug-in Communicator
Interface
Bosch Security Systems, Inc.