Heel Loop Replacement - Invacare 9000 Standard Weight User Manual

5 FRONT RIGGINGS
5.3

Heel Loop Replacement

Swingaway Footrests/Elevating Legrest (J932A, J932A-14, J933A and J934A)
1. Remove the four mounting screws and washers that secure the heel loop to the BOTTOM of the footrest.
2. Remove the heel loop from the footrest.
3. Position the new heel loop as shown in FIGURE 3 and reverse STEPS 1-2 to reassemble.
Elevating Legrest (J934A-14 ONLY)
1. Loosen, but do not remove the bolt and locknut that secure the lower half of the footrest to the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and locknut that secure the heel loop to the footrest.
4. Slide heel loop over cane of the footrest assembly.
5. Replace heel loop.
6. Reverse STEPS 1-4 to reassemble.

When securing the heel loop to the footrest assembly, tighten the mounting screw and locknut until the spacer is secure.
JA932A,
JA932A-14,
J933A, J934A
Footrest
Washer
Mounting Screw
Invacare® Jymni™ Pediatric Series Wheelchair
Heel Loop
FIGURE 3 Adjusting the Elevating Legrest Assembly
36
Mounting Screw
Spacer
J934A-14
Locknut
Bolt and Locknut
Heel Loop
Cane
Lower Footrest
Assembly
Part No 1100868