Heel Loop Replacement; Swingaway Footrests/Elevating Legrest (J932A, J932A-14, J933A And J934A); Elevating Legrest (J934A-14 Only) - Invacare 9000 Jymni Pediatric Series Maintenance Manual

Heel Loop Replacement

NOTE: For this procedure, refer to FIGURE 4.3.
Swingaway Footrests/Elevating Legrest (J932A, J932A-14, J933A and
J934A)
1. Remove the four mounting screws and washers that secure the heel loop to the
BOTTOM of the footrest.
2. Remove the heel loop from the footrest.
3. Position the new heel loop as shown in FIGURE 4.3 and reverse STEPS 1-2 to
reassemble.

Elevating Legrest (J934A-14 ONLY)

1. Loosen, but do not remove the bolt and locknut that secure the lower half of the
footrest to the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the mounting screw and locknut that secure the heel loop to the footrest.
4. Slide heel loop over cane of the footrest assembly.
5. Replace heel loop.
6. Reverse STEPS 1-4 to reassemble.
NOTE: When securing the heel loop to the footrest assembly, tighten the mounting screw and
locknut until the spacer is secure.
JA932A,
JA932A-14,
J933A, J934A
Footrest
Heel Loop
Mounting Screw
Part No 1100868
Mounting
J934A-14
FIGURE 4.3 Heel Loop Replacement
33
SECTION 4—FRONT RIGGINGS
Screw
Spacer
Locknut
9000 Jymni™Pediatric Series
bolt and Locknut
Heel Loop
Cane
Lower
Footrest
Assembly