Table of Contents
Advertisement
5.4
Installing/Removing Elevating Legrest Assembly
Installing
1.
Place elevating legrest assembly on the outside of the wheelchair
and install the hinge plates onto the hinge pins on the wheelchair
frame.
2.
Rotate elevating legrest assembly toward the inside of the
wheelchair until it locks in place.
3.
Repeat this procedure for other legrest assembly.
The footplates will be facing each other when locked in
place.
4.
After seated in wheelchair, adjust the legrest to correct height.
Refer to Installing/Removing Elevating Legrest Assembly on
page 37.
Removing
1.
To release the elevating legrest assembly, push the legrest release
handle toward the inside of the wheelchair (facing the front of the
wheelchair) and swing the legrest assembly to the outside of the
wheelchair.
2.
Lift the elevating legrest assembly off of the hinge pins.
Part No 1100868
Step 1
Bolt and Locknut
Steps 2 & 3
Hinge Pins
FIGURE 4 Installing/Removing Elevating Legrest Assembly
37
Invacare® Jymni™ Pediatric Series Wheelchair
5 FRONT RIGGINGS
Calfpad Assembly
Lower Footrest Assembly
Footplate
Hinge Plates
Elevating Legrest
Assembly
Legrest Release
Handle
J934A-14 shown.
J934A installs the same way.
Advertisement
Table of Contents
Troubleshooting
