Installing Calf Strap; Heel Loop Replacement - Invacare 9000 Topaz Owner's Operator And Maintenance Manual

Installing Calf Strap

NOTE: For this procedure, refer to FIGURE 4.6.
1. Remove calf strap from packaged container if it is not already secured to the footrest.
2. Secure one side of the calf strap around each footrest.

Heel Loop Replacement

NOTE: For this procedure, refer to FIGURE 4.7
1. Remove the two (2) bolts and locknuts that secure the lower footrest assembly to the
upper footrest support.
2. Remove the lower footrest assembly.
3. Remove the mounting screw, spacer and locknut that secure the existing heel loop to
the footrest.
4. Slide existing heel loop over the slide tube of the lower footrest assembly.
5. Install new heel loop.
6. Reverse STEPS 1-4 to reassemble.
NOTE: When securing the heel loop to the footrest assembly, tighten the mounting screw and
locknut until the spacer is secure.
Part No. 1100869
Calf Strap
Footrest
Footrest
FIGURE 4.6 Installing Calf Strap
Bolts
Mounting
Screw
Spacer
Locknut
FIGURE 4.7 Heel Loop Replacement
SECTION 4—FRONT RIGGINGS
Locknuts
Heel Loop
Slide Tube
Lower
Footrest
Assembly
29
9000 Topaz™Wheelchair