Table of Contents
Advertisement
10 ANTI-TIPPERS/WHEEL LOCKS
Adjusting Anti-Tippers
A 1½ to 2-inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times.
1.
Place the wheelchair on a flat, level surface.
On recliner models, ensure back canes are in the upright position before determining 1-1/2 to 2-inch clearance.
2.
Press the release buttons on the wheeled portion of the anti-tipper and slide it up or down to achieve the 1-1/2 to 2-inch clearance (Detail "A").
3.
Check to make sure that the release buttons are fully engaged in adjustment holes and ensure both anti-tippers are adjusted to the same height.
4.
Check to make sure that a 1-1/2 to 2-inch clearance between the bottom of the anti-tipper wheels and the ground/floor has been achieved
BEFORE using the wheelchair.
5.
Repeat STEPS 1-3 until 1-1/2 to 2-inch clearance is achieved.
Invacare® Jymni™ Pediatric Series Wheelchair
Detail "A"
Release Buttons
2 inches
1½ inches
FIGURE 2 Adjusting Anti-Tippers
Anti-Tipper
Height
56
Detail "B"
Anti-Tipper
Length
Part No 1100868
Advertisement
Table of Contents
Troubleshooting
