About The Remote Control Unit; Inserting The Batteries; Operating Range Of The Remote Control Unit; Remote Control Settings (Remote Control Side) - Denon DVD-A1UD Owner's Manual

About the Remote Control Unit

Inserting the Batteries

q Remove the remote control w Set three R6/AA batteries in
unit's rear cover. the battery compartment in the
indicated direction.
Batteries
e Put the rear cover back on.
NOTE
• Use R6/AA batteries in this remote control.
• Replace the batteries with new ones if the set does not operate
even when the remote control unit is operated close to the unit.
(The supplied batteries are only for verifying operation.)
• When inserting the batteries, be sure to do so in the proper direction,
following the "q" and "w" marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
Do not use a new battery together with an old one.
Do not use two different types of batteries.
Do not attempt to charge dry batteries.
Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
• Used batteries should be disposed of in accordance with the local
regulations regarding battery disposal.
Operating Range of the Remote Control
Unit
Point the remote control unit at the remote sensor when operating
it.
30°
30°
Approx. 7 m
NOTE
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or infrared
light.
Remote Control Settings (Remote
Control Side)
Switches when the DVD-A1UD's remote control operates another
DENON BD players in the vicinity.
Set the remote control code simultaneously on the main unit, too.
For how to set codes, see GUI menu: "Other Setup" – "Remote
Control Setting" – "Remote ID" (vpage 32).
GRemote control code settingH
: Set the remote control code to "1".
1
: Set the remote control code to "2".
2
• If the signal code of the remote control does not match the signal
code of the unit, the remote control code set on the unit is shown
on the display.
GExampleH
If the code setting on the unit is "DENON 1", and the setting on the
remote control is "2", "PLAYER 1" is shown on the display.
NOTE
• Match the signal code of the remote control with the signal code of
the unit. If the remote control code is different, you cannot operate
the DVD-A1UD with the remote control.
• Even if you change the remote control code, set GUI menu "Other
Setup" – "Remote Control setting" – "Receive Legacy Remocon"
(vpage 32) to "Off" when operating the DVD-A1UD with a remote
control other than DENON's.
ENGLISH