W## Close Window Start; W## Close Window Stop; Table 19: W# Close Window Stop Programming Example - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 2.0
0101
Disabled windows have a blank "begin"
0101
time. If the entry for this prompt is blank, but
0101
the times are programmed for Close
Window Start and Close Window Stop the
window is disabled.
To disable the window, both the hours and minute
spaces must be blank.
00:00 is Midnight and 23:59 is 11:59 p.m. Make
entries using a 24 hr. clock. For example, 7:00 a.m.
is entered as 07:00, and 2:45 p.m. is entered as
14:45.
0101
Disable/Restart the panel to activate today's
0101
window. If you are programming a window
0101
that needs to activate on the same day that
you are programming it, do a disable/restart
after programming.

W## Close Window Start

Default: _ _ : _ _
HH:MM (hours and minutes)
Selection:
Enter the time that you want the panel to start the
closing window. The window goes into effect at the
beginning of the minute.
A warning tone sounds and PLEASE CLOSE NOW
displays at the command center if the area is not
Close Window Start
armed when the
To temporarily silence the tone, press the [ESC] key
on the command center. The warning tone restarts
in ten min. if the area is not armed.

Table 19: W# Close Window Stop Programming Example

W# Day of Week
1
S M T W T F S
2
S M T W T F S
Bosch Security Systems | 2/04 | 74-06145-000-D
Area Wide Parameters
time comes.
OPEN CLOSE
Early Start Stop Early
Begin Begin
22:00
00:00
Close Early Begin
See
explanations.

W## Close Window Stop

Default: _ _ : _ _
HH:MM (hours and minutes)
Selection:
Enter the time that you want the panel to start the
closing window. The window stops at the end of a
minute.
If the area is not armed by the time the
Window Stop time expires, the panel generates a
Fail to Close
report if enabled in
Close Early Begin
See
explanations.
0101
Do not use a time of 23:59 as a window
0101
stop time unless the window continues on
0101
the next day at 00:00. Fail to Close reports
are not sent, and the Auto Close feature
does not work for windows that stop at
23:59.
Do not program a single window to cross
the midnight boundary. The window stop
time must be later than the window start
time. To program a window that effectively
crosses the midnight boundary, you have to
program two windows.
For example, to program windows for an
area that closes between 11:30 p.m. and
12:30 a.m., five days a week, use two
windows as shown in Table 19
Start Stop eXcept On
Holiday
23:30 23:59 Yes No
00:00 00:30 Yes No
EN | 38
for report feature
Close
Fail To Close
.
for other report feature
Holiday Area(s)
Index
1 2 3 4 1 2 3 4 5 6 7 8
1 2 3 4 1 2 3 4 5 6 7 8