Bat Fail/Res Rpt; Printer Parameters; Printer Address; P## Scope - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 1.0

Bat Fail/Res Rpt

Determines if battery (DC) power supervision
reports are sent.
Default: Yes
Selection: Yes or No
Battery Failure
Yes
number programmed for Power/Phone events.
Modem Reports:
BFSK Reports:
Battery Failure and Restoral reports are NOT sent to the central station.
No
Note:
When a battery problem occurs, the trouble buzzer sounds at the command centers unless it is disabled by
Buzz
(see AC/Battery Buzz).
1.4

Printer Parameters

Up to three D9131 Printer Interface Modules can be
connected to the D9112's SDI bus. Each printer is
identified by an address of 17, 18, or 19. Options
Routing
are available for
assignments.

P## Scope

Press the [SPACE] bar to scroll through the selections. Press [ENT] when the correct selection appears in the
display.
Default: No Printer
Selection: No Printer, Panel Wide, Account, and Area
No Printer Printer disabled
Panel Wide Printer prints all designated events that occur panel-wide. A panel-wide printer crosses account
boundaries.
Account Printer prints all designated events that occur in the area where the printer is assigned and all other
areas that are assigned to the same account. A single account printer displays all the information in
the account but cannot cross boundaries.
Area Printer prints all designated events that occur in the assigned area.
Bosch Security Systems | 2/04 | 74-06145-000-D
Panel Wide Parameter
Restoral
and reports are sent to the central station. They are routed to the telephone
Missing or shorted
Discharged below 12.1 VDC
Missing, shorted, low battery
reports and area
The battery must be discharged below 12.1 VDC for
16 sec. before the D9112 responds to a low battery
(see the D9112 Operation and Installation Guide for
discharge schedule).
BATTERY MISSING
BATTERY LOW
TROUBLE ZONE 9

Printer Address

Default: 17
Selection: 17, 18, or 19
The printer address you are programming.
EN | 20
AC/Battery