Replacing The System Board - Gateway 9415 User Manual

Replacing the system board

To replace the system board:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord(s) and all other cables
connected to the server.
2
Follow the instructions in
3
Remove the processor air duct by following the instructions in
processor air duct" on page
4
Remove the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
5
Remove the memory modules by following the instructions in
on page 66.
6
Remove the fan module by following the instructions in
modules" on page
7
Remove the heat sinks and processors by following the instructions in
processor" on page
8
Disconnect all cables from the system board, noting their locations and orientation.
(You will reconnect the cables after you install the new board.)
102
"Preventing static electricity discharge" on page
"Opening the server case" on page
45.
76.
82.
www.gateway.com
69.
"Replacing fans and fan
41. Make
42.
"Removing the
"Removing and
"Installing memory"
"Installing a