Replacing The System Board - Gateway 9315 User Manual

Replacing the system board

To replace the system board:
1
Follow the instructions in
sure that you turn off the server, then unplug the power cord and all other cables
connected to the server.
2
Follow the instructions in
3
Follow the instructions in
4
Remove the memory modules by following the instructions in
on page 65.
5
Remove the PCI riser assembly by following the instructions in
installing the PCI riser assembly" on page
6
Remove the heat sinks and processors by following the instructions in
processor" on page
7
Disconnect all cables from the system board, noting their locations and orientation.
(You will reconnect the cables after you install the new board.)
8
Remove the 9 screws that secure the system board to the server.
Screw
2 screws
(below PCI
riser
assembly)
Screw
88
"Preventing static electricity discharge" on page
"Opening the server case" on page
"Removing the processor air duct" on page
76.
Screw (below processor air duct)
Screw Screw
www.gateway.com
69.
Screw
37. Make
38.
41.
"Installing memory"
"Removing and
"Installing a
Screw