Replacing The System Board - Gateway 920 User Manual

Replacing the system board

To replace the system board:
1
Follow the instructions in
page 41.
2
Open the server case by following the instructions in
case" on page
3
Remove all of the expansion cards by following the instructions in
"Installing PCI expansion cards" on page
4
Unplug the heat sink's cooling fan, then remove the heat sink and
processor by following the instructions in
page 58.
5
Remove the memory modules by following the instructions in
memory" on page
6
Disconnect the power and data cables from the system board, noting their
locations and orientation. (You will reconnect the cables after you install
the new board.) Make sure that you disconnect the intrusion switch cable.
7
Remove the system board's thumbscrew.
"Preventing static electricity discharge" on
42.
54.
Intrusion switch connector
www.gateway.com
Replacing the system board
"Opening the server
56.
"Replacing the processor" on
Thumbscrew
"Installing
63