Peripheral/Adapter Problems - Gateway E3400 System Manual

Peripheral/adapter problems

A SCSI device is not recognized by the system.
Probable Cause
The device needs to be
added as new hardware.
The SCSI ID may be invalid.
The SCSI chain is not
terminated.
The device cables are not
installed correctly.
The diskette drive is not recognized by the system.
Probable Cause
The diskette drive may be
configured incorrectly.
The drive cables are not
connected properly.
The drive controller is not
seated properly.
Important
88
Troubleshooting
Solution
From the Control Panel window (Start |
Settings | Control Panel), double-click Add
New Hardware. Follow the directions for
adding the device. If you are not experienced
with this procedure, call technical support.
Assign an available SCSI ID to the device.
Make sure the last device on the SCSI chain
is terminated.
Open the system and check all cables
between the controller and the device.
Solution
Restart your computer, then press F1 to enter
the BIOS Setup utility. From the Boot |
Removable Devices menu, make sure that
the diskette drive parameters are set correctly.
Open the system and check all cables
connected to the controller card.
Open the system and reseat the drive
controller.
Some systems do not have a floppy (diskette) controller
card because the floppy controller is built into the system
board.