Setting The System Board Jumpers; Recovery Mode - Gateway E3400 System Manual

Setting the system board jumpers

The JP6 configuration jumper on the system board lets you clear passwords
and recover the BIOS. (See the figure on page 8 for the location of the jumper.)
The following table shows the settings required to perform those tasks. Make
sure you turn off the computer and unplug the power cord before moving
the jumper.
Caution
JP6 Mode
Normal
Configure
Recovery

Recovery mode

If you are trying to update the BIOS and have a problem such as a power
outage, the update may not be successful. You can then attempt to recover
the BIOS by setting the JP6 jumper.
When you are attempting to recover the BIOS, no image appears on your
monitor.
66
Using the BIOS Setup Utility
Moving the jumper while the computer power is on can
damage your computer. Always turn off the computer and
unplug the power cord from the computer before changing
the jumper.
Jumper
Setting
Pins 1-2
Pins 2-3
No jumper
Action When Set
Normal operation
Adds a Maintenance menu to
BIOS Setup utility with options to
clear passwords
Causes computer to attempt
BIOS update or recovery from
diskette