Deleting Individual Select Scan Channels; Deleting All Select Scan Channels; Start, Pause And Cancel Select Scan - AOR AR8000 Operating Manual

11-5 DELETE individual "SELECT SCAN" channels
To access the "SELECT SCAN" EDIT menu place the receiver into VFO mode
then press [FUNC] [PASS].
The "SELECT SCAN" menu displays the legend "SELECT SCAN" to confirm
operation. The left side of the second line of the LCD displays "CH-00" with
the highlight cursor flashing on the first "0". The "CH-00" refers to the 100
SELECT CHANNELS of the special list which are numbered 00 - 99
(examples are CH-00, CH-01, CH-03 etc).
To delete channels, select the desired channel by rotating the [DIAL] or using
the UP/DOWN keys. A "vacant" position will have no data to the right of the
LCD and the blank indicator "- - -" displayed.
Press [ENT] to enter EDIT mode. The highlight cursor will move to the right
hand data field of the second line of the LCD. Press [PASS] to DELETE
(un-tag) the memory channel from the SELECT SCAN LIST. The data in the
list will "shuffle" down to fill the empty channel and a vacant channel will
appear at the top of the list.
11-6 Deleting all SELECT SCAN channels in one go
It is often convenient to delete ALL the SELECT SCAN channels in a single
operation. This makes the list ready for a fresh start perhaps using a totally
different selection of SELECT SCAN channels.
While this may be accomplished by deleting each and every SCAN SELECT
channel individually or "un-tagging them", a faster method is available
especially if you have previously selected all 100 select scan channels.
First place the receiver into the 2VFO operating mode by pressing [2VFO].
Access the main "SELECT-DEL" by keying [FUNC] [9]. Use the UP/DOWN
or [DIAL] until "SEL-SCAN appears as an option on the fourth line of the LCD.
Position the cursor to the left of the "SEL-SCAN" option then press [ENT].
All SELECT SCAN channels will be "un-tagged" and deleted from the SELECT
SCAN list. The receiver will return to 2VFO mode.

11-7 START, PAUSE and CANCEL SELECT SCAN

To initiate a SELECT SCAN press [FUNC] [5], the legend "SEL" will be
displayed on the top left of the LCD to indicate that SELECT SCAN has been
selected.
To stop the SELECT SCAN process while scanning press [SCAN]. To resume
select scan again press [FUNC] [5]. To cancel select scan return to VFO by
pressing [2VFO].