Auto Store; Auto Store In Newuser Status - AOR AR8000 Operating Manual

(15) AUTO STORE - automatic memory write from
program search mode
The AR8000 features an Automatic memory write facility.
AUTO STORE automatically writes the frequency, mode, step, step offset,
attenuator and comment of the first 50 "active" frequencies located in any
program search to memory bank "J". In default status as shipped from the
factory and when in NEWUSER mode the AUTO STORE facility is switched
"ON".
This is particularly useful for locating interesting "active" frequencies during
program search especially when left unattended.
If you had left the unit unattended while program searching, you need only
check the memory channels of bank "J" to see the first 50 frequencies which
had become active while you were unavailable. This memory bank may then
be scanned to further analyse the results or the frequencies "copied, moved or
swapped" to more appropriate memory banks / channels.
Note: Frequencies less than +/- 10 kHz of a previously stored frequency will
not be automatically stored.
In EXPERT status, you may choose to switch the AUTO STORE facility ON/
OFF.
15-1 Using AUTO STORE in NEWUSER status
In NEWUSER status as shipped from the factory the AUTO STORE facility is
switched "ON" and memory bank "J" is used to store the data located in
program search mode.
When you first wish to use the facility, it is best to delete the contents of
memory bank "J" (where the search frequencies will be automatically saved to
memory) in order to provide meaningful information.
Only the first 50 "active" frequencies will be automatically stored and will be
written to memory in ascending memory channel order from 00 - 49 until all 50
channels have been used. Active frequencies located after the 50th channel
has been used will not be stored. This limitation is to prevent unnecessary
writing to the EEPROM data store.
Deleting ALL channels of memory bank "J" before AUTO STORE
First place the receiver into the 2VFO operating mode by pressing [2VFO].
Access the main "SELECT-DEL" by keying [FUNC] [9]. Use the UP/DOWN or
[DIAL] until the cursor is to the left of the "MEMO-DATA" option then press
[ENT].