Select Scan Using The Menu - AOR AR8000 Operating Manual

Each time the sequence [FUNC] [PASS] is keyed then the SELECT SCAN
status "s" is toggled so that the channel may be "tagged" (chosen / registered)
and "un-tagged" at will.
Note: If memory channels are set as "PASS" (with a lower case "p" being
displayed), the letter will be over-written by the letter "s" for SELECT SCAN.
The status of PASS has not been changed for standard SCAN mode but
SELECT SCAN "tagged" channels ignore the status of PASS. If the channel is
"un-tagged", the letter "p" will reappear indicating that its PASS status has not
been changed.
To initiate a SELECT SCAN press [FUNC] [5], the legend "SEL" will be
displayed on the top left of the LCD to indicate that SELECT SCAN has been
selected.
11-3 SELECT SCAN using the "SELECT SCAN" EDIT menu overview and
terminology
When using the EDIT menu, a LIST is used to SELECT and DELETE memory
channels. For this reason the SELECT SCAN terminology is slightly different
from that used in the SCAN and MEMORY RECALL modes.
SELECT / CHOOSE / REGISTER = TAG: In SCAN or MEMORY RECALL
modes channels are "tagged" when they are added to the list and a lower case
"s" signifies the tag. In the EDIT menu there is no "tag". The fact that the
channel appears in the LIST indicates that it IS TAGGED! For this reason
TAG = SELECT.
DELETE = UN-TAG: The fact that the channel is deleted from the LIST
indicates that it IS NO LONGER TAGGED, it IS UN-TAGGED! For this reason
UN-TAG = DELETE.
Once you have completed this section, try adding and deleting channels
to and from the list then reviewing the "tag" status using memory recall
to fully familiarise yourself with the terminology and process.
To access the "SELECT SCAN" EDIT menu place the receiver into VFO mode
then press [FUNC] [PASS].
The "SELECT SCAN" menu displays the legend "SELECT SCAN" to confirm
operation. The left side of the second line of the LCD displays "CH-00" with
the highlight cursor flashing on the first "0". The "CH-00" refers to the 100
SELECT CHANNELS of the special list which are numbered 00 - 99 (examples
are CH-00, CH-01, CH-03 etc).
To review the contents of the SELECT SCAN LIST
rotate the [DIAL] or use the UP/DOWN keys. Only
SELECT SCAN LIST channels with data will be
displayed plus the first vacant channel. Channels are
allocated in ascending numeric order.