Expert Scan Options - AOR AR8000 Operating Manual

The receiver will display a memory channel, mode, frequency, text and scan
PASS status.
If the desired memory channel to be PASSED (locked out) is not immediately
displayed, the [DIAL] may be rotated to review specific memory scan
channels. Alternatively the memory channel location may be quickly recalled
by keying in the required location using the keypad.
For example, to recall memory channel "A00" type [1A] [0] [0] there is no
need to press enter. When keying, the "M.RE SELECT" menu automatically
appears when the [1A] key (or any other bank identifier) is pressed so that the
frequency and comments are displayed on the third and fourth lines of the LCD
for easy recognition.
When the memory channel has been selected, a
lower case (small) letter "p" to the left of the
frequency on the second line of the LCD indicates
SCAN MEMORY CHANNEL PASS. Pressing [PASS]
when in memory recall mode toggles the status of
the displayed memory channel scan pass (lockout),
"p" = PASS.
The receiver will monitor whatever memory channel is
displayed in "M.RE" mode when manually selected
whether the "p" PASS indicator is shown or not.
Note: If you have activated the PASSWORD protection, it is not possible
to access memory banks a, b, c, d, e, f, g, h, i, j until the password has
been keyed in each time the set has been switched On. Please refer to
section 9 of this manual for further information.
10-12 Additional SCAN options in EXPERT status
It is possible to alter the sequence of scanning events when in EXPERT
status depending upon the SCAN CONFIGURATION as defined in the
"SET M-SCAN" sub menu.
There are 5 scanning which may be changed to suit your preferences and
requirements. The list of scanning defaults is shown below:
SCAN TYPE
DELAY
AUDIO
FREE
LEVEL
MODE
* It is possible to mix combinations of all five parameters. *
NEWUSER
2.0 seconds
OFF
OFF
OFF
ALL
EXPERT
0.0 (OFF) - 9.9 seconds
OFF/ON
00 (OFF) - 99 seconds
0 (OFF) - 7 in 7 steps
ALL/WFM/NFM/AM/USB/LSB/CW