AOR AR8000 Operating Manual page 16

switchable for use in locations of low level lighting.
The basic operational description of each key is as follows:
[SRCH] - search key
When first pressed initiates the search process and "SRCH" is displayed at the
top left of the LCD.
When [SRCH] is pressed a second time during search, the SEARCH process
is cancelled and the current search frequency is left as a single frequency
readout on the LCD. This can be useful should you wish not to have 2-VFO
display but wish for a single frequency display... just press [SRCH] twice while
searching.
If the search process had stopped on an "active" frequency when [SRCH]
was pressed for the second time, the process would be forced to continue
searching passed the busy frequency.
When in SEARCH mode, the display legend "SRCH" appears on the LCD.
If the sequence [FUNC] [SRCH] is keyed while in search mode the receiver
enters the "SET SEARCH" menu where search banks may be linked and
unlinked.
While in search mode and stopped on an interesting active (busy) frequency,
press [FUNC] [2VFO] to transfer the busy frequency to the "active" (top) VFO
and revert to VFO mode.
[SCAN] [M.R] - scan / memory recall key
When pressed the first time initiates memory recall, the display legend "M.RE"
appears on the LCD. The numeric keypad may then be used to recall a
specific memory channel or the [DIAL] rotated to scroll through the contents.
To transfer a memory channel to VFO press the [ENT] key.
When [SCAN] is pressed a second time (this means pressing while "M.RE" is
displayed), the receiver enters memory SCAN mode. When
SCAN mode has been entered, the display legend "SCAN" appears on the
LCD.
When [SCAN] is pressed while in SCAN mode ("SCAN" displayed), the SCAN
process is cancelled and the current SCAN frequency is left on the LCD.
If the scan process had stopped on an "active" channel when [SCAN] was
pressed for the second time, the process would be forced to continue scanning
passed the busy channel.
If the sequence [FUNC] [SCAN] is keyed while in SCAN mode the receiver
enters the "SET M-SCAN" menu where memory banks may be linked and
unlinked.
While in scan mode and stopped on an interesting busy channel, press
[FUNC] [2VFO] to transfer the busy channel to the "active" (top) VFO and