Deleting Program Search Banks - AOR AR8000 Operating Manual

To accept the changes to FREE search press [ENT] to return to SEARCH
mode.
Alternatively you may move to the next option (LEVEL SEARCH) by pressing
the [DOWN] key.
SEARCH - LEVEL search
LEVEL search causes the receiver to check the signal strength of "active"
frequencies and only stops when signal strength is above a predetermined level
which is programmable in 7 steps plus OFF.
The limits are 1 to 7 levels with zero being interpreted as LEVEL search OFF.
Note: It is possible that false signal levels may upset the operation of
LEVEL search due to local noise or the close proximity of computer
systems.
Either use the [DIAL] to change the value or key in a one digit number through
the numeric keypad. [0] is accepted as zero (OFF) and [4] as level 4.
To accept the changes to LEVEL search press [ENT] to return to SEARCH
mode.
13-10 Deleting program search bank data
It is possible to delete the programming of a search bank in two ways. Of
course it is also possible to simply type new program search data over an
existing search bank.
Delete program search bank data while in SEARCH mode
Ensure the receiver is in search mode ("SRCH" in the top left corner of the
LCD).
Press [FUNC] [9], the "SRCH-DATA DELETE" menu
is displayed with the highlight cursor flashing over the
bank identifier of the current search bank being
searched.
If this is not the program search bank which you wish
to delete, use the keypad, [DIAL] or UP/DOWN keys
until the desired bank identifier is displayed.
Remember, if you have set the password then it must
be keyed in to access the protected banks.
When the desired program search bank identifier is displayed, press [ENT] to
delete the data.
The receiver will return to SEARCH mode but will move to the next program
search bank either above or below the deleted bank depending upon the