Select Scan; Start Select Scan; Select Scan Setting; Duo Frequency / Tri Frequency Receive - AOR AR2300 Operating Manual

4-6 Select scan

4-6-1 Start select scan

The Select scan function allows you to scan only a selection of the frequencies that were
previously saved as memory channels. A maximum of 100 channels within a bank can be scanned.
SM
LC

4-6-2 Select scan setting

GA
GD
To read: GR<CR>
GRnnnn
Response:

4-7 Duo frequency / tri frequency receive

The Duo frequency / Tri frequency receive functions allow you to monitor two or three separate
frequencies simultaneously.
4-7-1 Duo frequency receive (duo band receive mode)
With this function, one frequency below 25MHz set on the VFO-E (as a sub band) and
another frequency above 25MHz set on the VFO (other than VFO-E, as a main band) can be received
simultaneously.
The received audio for both frequencies are available at the headphone jack independently.
Mixed audio for both signals is available at the external speaker jack.
Below are the requirements for Duo frequency receive function:
(For main band)
Frequency must be above 25MHz.
The FM stereo mode is not available in this mode.
The receiver must be in the VFO mode and it must be set other than VFO-E.
The antenna input must use number 1.
(For sub band)
Frequency must be below 25MHz.
The VFO must be set to VFO-E.
37
SM (direct command)
n: 0, 1
LCn:
0: No report (default)
1: Output detected frequency information
n: 0, 1
GAn:
0: Select scan Off
1: Select scan On (default)
Clear select memory (direct command)
GD
(Displays select scan memory list)