AOR AR8000 Operating Manual page 84

Rotate the [DIAL] to indicate "25.00" on the third line of the LCD to select a 25
kHz step size.
If EXPERT status has been selected (as shown in section 6-3 of this manual)
the channel step may be input using the keypad. Valid step sizes are multiples
of 50 Hz.
If specifying your own channel step remember that the receive frequency
must be divisible by the step size. If it is not, the receive frequency will be
automatically recalculated by the AR8000 and the closest divisible frequency
later displayed.
Should you make a mistake while entering the new frequency, the [UP] arrow
key will act as backspace edit to correct frequency input.
CHANGE FREQUENCY: The cursor moves to left of the second line of the
LCD over the legend "S" with "0.0" to the far right. The "S" indicates that the
start (lower of the two limits) frequency is required.
Press [4] [3] [3] [ENT] to set the new start (lower) frequency to 433.000 MHz.
The cursor moves to left of the third line of the LCD over the legend "E" with
"0.0" to the far right. The "E" indicates that the end (upper of the two limits)
frequency is required.
Press [4] [3] [3] [.] [6] [ENT] to set the new end (higher) frequency to 433.600
MHz.
Should you make a mistake while entering the new frequency, the [UP] arrow
key will act as backspace edit to correct frequency input.
TEXT INPUT/CHANGE: The highlight cursor will move to the fourth line to
the right of the legend "TXT". Rotate the [DIAL] on the top cabinet until the
chosen letter or symbol is displayed. A maximum word length of seven
characters may be chosen and our example calls for "70CM". To move to the
right and left character positions use the arrow keys.
Note: If you do not wish to add or change an alphanumeric comment, simply
press [ENT] to skip the option and finalise the data input.
If you are happy with the alphanumeric description press [ENT] which also
completes the program search bank "J" data entry and returns the display at
2VFO mode.
Notes on program search bank programming
There is no need to delete program search bank data before programming. If
data is already present, it may simply be over-written.
Should you initiate program search bank programming while in search mode,
the receiver will return to search mode upon completion of data entry.
To ABORT the SRCH-SELECT menu at any time press [CLEAR].