Select Scan - While In Scan Mode; Select Scan While In Memory Recall Mode; Starting Select Scan; Deleting All Select Scan Channels In One Go - AOR AR5000 Operating Manual

10-2 SELECT SCAN - while in SCAN
mode (tagging and un-tagging)
While the receiver is scanning, the AR5000 will stop on
active frequencies and you will soon realise that some
are interesting and some uninteresting .
To build up your select scan list of interesting channels,
start to tag the interesting channels while the scan
sequence pauses on active memory channels by pressing
The legend " " will be displayed next to the bank number
of the memory channel to confirm selection.
Each time the sequence
SELECT SCAN status " " is toggled so that the channel
may be tagged (chosen / registered) and un-tagged
at will.
Tagging a memory for SELECT SCAN will not force the
scan to continue nor affect the way in which the memory
channel or SCAN mode operates. When the signal
disappears normal SCAN mode is resumed.
10-3 SELECT SCAN while in MEMORY
RECALL mode (tagging and un-tagging)
SELECT SCAN channels may be tagged or un-tagged
while in memory recall mode by first selecting the desired
memory channel then keying
If not already in memory recall mode, press
legends "M" and "BANK" are displayed on the LCD to
confirm selection of memory recall.
The AR5000 will display a memory channel, mode,
frequency (or TEXT if text mode is selected). You may
now select and tag interesting memory channels to add
to the SELECT SCAN list from any of the ten memory
banks.
If the desired memory channel is not immediately displayed
it may be RECALLED by keying in the required location.
To recall memory channel "
is no need to press enter.
Alternatively the
be used to review, hunt for and select memory channels
PAGE 44 AR5000 OPERATING MANUAL
is keyed, the
. The
" type
, or keys may
to be tagged or un-tagged , the
bank number.
When the memory channel has been tagged using the
sequence
next to the bank number of the chosen memory channel
to confirm selection.
Each time the sequence
SELECT SCAN status " " is toggled so that the channel
may be tagged (chosen / registered) and un-tagged
at will.

10-4 Starting SELECT SCAN

To initiate SELECT SCAN once a selection of channels
has been made press
SELECT SCAN will scan only the memory channels which
have been chosen ( tagged ) and will adopt the current
PARAMETERS which have been saved in the currently
selected BANK LINK configuration. In the default state,
the scan will remain on an active channel then wait a further
two seconds after the signal has disappeared before
resuming SCAN. If you have altered the BANK LINK /
SETUP parameters (section 9 of this manual), the new
parameters will be employed.
If no memory channels have been tagged for SELECT
SCAN, the error bleep will sound (if the beep tone has
been enabled).
10-5 Deleting all SELECT SCAN channels
in one go
It is convenient to delete ALL the SELECT SCAN channels
in a single operation. This makes the list ready for a fresh
start, perhaps using a totally different selection of SELECT
SCAN channels.
While this may be accomplished by untagging each and
every SCAN SELECT channel individually, a faster method
is available especially if you have previously selected all
100 select scan channels.
Access the DELETE menu by pressing
press and hold the
there
Use the
appears on the LCD.
is used to change
, the legend " " will be displayed
is keyed, the
key for more than one second.
keys until "
then
"