Table 12 Network > Wan > Internet Access Setup - ZyXEL Communications P-793H User Manual

The following table describes the labels in this screen.
Table 12 Network > WAN > Internet Access Setup
LABEL
General
Transfer Mode
Mode
Encapsulation
User Name
Password
Service Name
Multiplexing
Virtual Circuit ID
VPI
VCI
P-793H v2 User's Guide
DESCRIPTION
Select the transfer mode you want to use.
PTM (Packet Transfer Mode): The P-793H v2 uses the SHDSL
technology for data transmission over the DSL port.
ATM (Asynchronous Transfer Mode): The P-793H v2 uses the ADSL
technology for data transmission over the DSL port.
Select Routing (default) from the drop-down list box if your ISP gives
you one IP address only and you want multiple computers to share an
Internet account. Select Bridge when your ISP provides you more
than one IP address and you want the connected computers to get
individual IP address from ISP's DHCP server directly. If you select
Bridge, you cannot use Firewall, DHCP server and NAT on the P-793H
v2.
Select the method of encapsulation used by your ISP from the drop-
down list box. Choices vary depending on the mode you select in the
Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC
1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483,
ENET ENCAP or PPPoE.
If you set up a point-to-point or a point-to-2points connection, select
either ENET ENCAP or RFC 1483.
(PPPoA and PPPoE encapsulation only) Enter the user name exactly as
your ISP assigned. If assigned a name in the form user@domain
where domain identifies a service name, then enter both components
exactly as given.
(PPPoA and PPPoE encapsulation only) Enter the password associated
with the user name above.
(PPPoE only) Type the name of your PPPoE service here.
Select the method of multiplexing used by your ISP from the drop-
down list. Choices are VC or LLC.
This is available only when you select ATM in the Transfer Mode
field.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define
a virtual circuit. Refer to the appendix for more information.
This is available only when you select ATM in the Transfer Mode
field.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for
local management of ATM traffic). Enter the VCI assigned to you.
Chapter 6 WAN Setup
79