Table 20 Network > Lan > Ip: Advanced Setup - ZyXEL Communications P-793H User Manual

The following table describes the labels in this screen.
Table 20 Network > LAN > IP: Advanced Setup
LABEL
RIP & Multicast Setup
RIP Direction
RIP Version
Multicast
Any IP Setup
Active
Windows
Networking
(NetBIOS over
TCP/IP)
Allow between
LAN and WAN
Packet Filter
Incoming Filter
Sets
Protocol Filter
Generic Filter
P-793H v2 User's Guide
DESCRIPTION
Select the RIP direction from None, Both, In Only and Out Only.
Select the RIP version from RIP-1, RIP-2B and RIP-2M.
IGMP (Internet Group Multicast Protocol) is a network-layer protocol
used to establish membership in a multicast group. The P-793H v2
supports IGMP-v1, IGMP-v2 and IGMP-v3. Select None to disable
it.
Select the Active check box to enable the Any IP feature. This allows
a computer to access the Internet via the P-793H v2 without
changing the network settings (such as IP address and subnet mask)
of the computer, even when the IP addresses of the computer and the
P-793H v2 are not in the same subnet.
When you disable the Any IP feature, only computers with dynamic IP
addresses or static IP addresses in the same subnet as the P-793H
v2's LAN IP address can connect to the P-793H v2 or access the
Internet through the P-793H v2.
Note: You must enable NAT/SUA in the NAT screen to use the
Any IP feature on the P-793H v2
NetBIOS (Network Basic Input/Output System) are TCP or UDP
packets that enable a computer to connect to and communicate with
a LAN. For some dial-up services such as PPPoE or PPTP, NetBIOS
packets cause unwanted calls. However it may sometimes be
necessary to allow NetBIOS packets to pass through to the WAN in
order to find a computer on the WAN.
Select this check box to forward NetBIOS packets from the LAN to the
WAN and from the WAN to the LAN. If your firewall is enabled with
the default policy set to block WAN to LAN traffic, you also need to
enable the default WAN to LAN firewall rule that forwards NetBIOS
traffic.
Clear this check box to block all NetBIOS packets going from the LAN
to the WAN and from the WAN to the LAN.
Select the protocol filter(s) to control incoming traffic. You may
choose up to 4 sets of filters.
You can configure packet filters in the Packet Filter screen. See
Chapter 12 on page 217
Select the generic filter(s) to control incoming traffic. You may choose
up to 4 sets of filters.
You can configure generic filters in the Packet Filter screen. See
Chapter 12 on page 217
for more details.
for more details.
Chapter 7 LAN Setup
105