Remote Node Network Layer Options; Figure 151 Menu 11.3: Remote Node Network Layer Options; Table 118 Menu 11.3: Remote Node Network Layer Options - ZyXEL Communications P-793H User Manual

Chapter 28 Remote Node Setup
Table 117 Menu 11.1: Remote Node Profile (nodes 1-7) (continued)
FIELD
Edit Filter Sets
Idle Timeout(sec)

28.4 Remote Node Network Layer Options

Move the cursor to the Edit IP/Bridge field in menu 11.1, then press [SPACE
BAR] to select Yes. Press [ENTER] to open Menu 11.3 - Remote Node Network
Layer Options.

Figure 151 Menu 11.3: Remote Node Network Layer Options

IP Options:
IP Address Assignment = Static
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Metric= 2
Private= No
RIP Direction= Both
Multicast= None
IP Policies=
The following table describes the fields in this menu.

Table 118 Menu 11.3: Remote Node Network Layer Options

FIELD
IP Address
Assignment
Rem IP Addr
Rem Subnet Mask
My WAN Addr
328
DESCRIPTION
If you want to specify input and output filter sets for the WAN port,
press [SPACE BAR] to select Yes and press [ENTER]. Menu 11.5
appears.
Enter the number of seconds the P-793H v2 should wait while there
is no Internet traffic before it automatically disconnects from the ISP.
Enter a time interval between 10 and 9999 seconds.
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= N/A
Version= RIP-2B
DESCRIPTION
Select Dynamic if your ISP did not give you a fixed (static) IP
address. Select Static if your ISP gave you a fixed (static) IP
address. The next three fields are not available if you select
Dynamic.
Enter the IP address of the remote (peer) computer to which the P-
793H v2 connects.
Enter the subnet mask of the remote (peer) computer to which the
P-793H v2 connects.
Enter the fixed (static) IP address provided by your ISP.
Bridge Options:
Ethernet Addr Timeout(min)= N/A
P-793H v2 User's Guide