Networking Configuration Submenu (Oncue Password) - Kohler 14/20RESA Operation

3.18.2 Networking Configuration
Submenu (OnCue Password)
The networking Configuration menu includes settings
used for communication with the Kohlerr OnCuet
Home Generator Management System.
For most applications, DHCP is enabled and the IP
settings cannot be changed from the controller keypad.
If DHCP is enabled, IP parameters are not displayed.
If DHCP is disabled (i.e., if a static IP address is
required), then the IP parameters can be modified. For
applications that require static IP addresses, press and
hold the select button to enable editing, disable DHCP,
and then step to the next parameters and enter the
information.
If an error occurs while setting a parameter, an error
message is displayed and then the controller exits the
edit mode. Previous settings are preserved.
Networking---->
Information
Figure 3-21 Network Configuration Submenu
TP-6804 12/11
Networking---->
Status
Networking
Reset OnCue
Configuration
Password
DHCP:
Enabled
<---- Return
Password
For the initial OnCue setup, you will be required to reset
the OnCue password on the RDC2 controller, and then
enter it into the OnCue software. To reset the password,
follow the instructions in Figure 3-21.
Note: The password is displayed for only 10 seconds.
Be sure to write down the password and serial
number.
A new password is generated each time the reset
password procedure is performed. If the password is
reset after the OnCue system has been set up, the
connection will be lost. Enter the new password in
OnCuer to reconnect.
HOLD
Reset OnCue
Password? No
Reset OnCue
Password? Yes
S/N: 1234567
New PW: 12345
Section 3 RDC2 Controller Operation
UP arrow for YES,
Down arrow for NO.
Press Select to enter YES
or NO as displayed. New
password is displayed for
approximately 10 seconds.
tp6804
45