Setting The Oncue Password - Kohler 6VSG Service Manual

3.9 Setting the OnCue Password

If the Kohler OnCue Generator Management System
is used to monitor the generator set, reset the OnCue
password as described below for the VSC.
See Figure 3-22 during this procedure.
1. Press Select and then press the down arrow
button to navigate to the networking Information
menu.
2. Press Select. Networking Status is displayed.
3. Press the Down arrow button.
Configuration is displayed.
Figure 3-22
Networking---->
Information
Figure 3-22 Setting the OnCue Password, VSC
TP-6844 1/13
Networking
Networking---->
Status
Networking
Reset OnCue
Configuration
Password
<---- Return
4. Press Select.
displayed.
5. Press and HOLD the Select button until Reset
OnCue Password? No appears. The word No
will flash.
6. Press the Up arrow button to change the word No
to Yes.
7. Press Select to reset the password.
generator set serial number and new password
are displayed for 10 seconds. Be sure to write
down the new password for entry into the OnCue
program.
HOLD
DHCP:
Enabled
Reset OnCue Password is
Reset OnCue
Password? No
UP arrow for YES,
Down arrow for NO.
Reset OnCue
Password? Yes
Press Select to enter YES
or NO as displayed. New
password is displayed for
approximately 10 seconds.
S/N: 1234567
New PW: 12345
Section 3 Controller
The
KPS_077
49