Introduction - Kohler 14/20RESA Operation

This manual provides operation and maintenance
instructions for residential/commercial
14/20RESA and RESAL generator sets equipped with
Kohler RDC2 or DC2 generator set/transfer switch
controllers. See Figure 1.
controllers control the generator set and the optional
Model RXT transfer switch.
This generator set is approved for use in stationary
applications in locations served by a reliable utility
power source. Have the generator set installed by an
authorized distributor/dealer or service technician.
Refer to TP-6803, Installation Manual, for installation
instructions.
Information in this publication represents data available
at the time of print. Kohler Co. reserves the right to
change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section at the
beginning of this manual. Keep this manual with the
equipment for future reference.
The equipment service requirements are very important
to safe and efficient operation. Inspect the parts often
and perform required service at the prescribed intervals.
Obtain service from an authorized service distributor/
dealer to keep equipment in top condition.
Figure 1 RESA/RESAL Generator Set
TP-6804 12/11
model
The RDC2 and DC2
List of Related Literature
Figure 2 identifies related literature available for the
generator sets covered in this manual. Only trained and
qualified personnel should install or service the
generator set.
Literature Type
Installation Manual, Model
14/20RESA/RESAL Generator Set
Operation/Installation Manual, Model
RXT Automatic Transfer Switch
Operation/Installation Manual, Model
RDT Automatic Transfer Switch
Installation Manual, Model RSB
Automatic Transfer Switch
Operation Manual, Model RSB
Automatic Transfer Switch
Service Manual, 14/20RESA/RESAL
Generator Set
Operation Manual, OnCuer Software
Operation Manual, SiteTecht Software
Installation Instructions, Load Control
Module (LCM)
Installation Instructions, Programmable
Interface Module (PIM)
Figure 2 Related Literature

Introduction

Part Number
TP-6803
TP-6807
TP-6345
TP-6486
TP-6487
TP-6735
TP-6796
TP-6701
TT-1574
TT-1584
Introduction 11