Networking Configuration Submenu (Oncue® Password) - Kohler 6VSG Operation Manual

3.16.2 Networking Configuration Submenu (OnCue® Password)
The networking Configuration menu includes settings used for communication with the Kohler
Management System. See Figure 34.
For most applications, DHCP is enabled and the IP settings cannot be changed from the controller keypad. If DHCP is enabled,
IP parameters are not displayed.
If DHCP is disabled (i.e., if a static IP address is required), then the IP parameters can be modified. For applications that require
static IP addresses, press and hold the select button to enable editing, disable DHCP, and then step to the next parameters and
enter the information.
If an error occurs while setting a parameter, an error message is displayed and then the controller exits the edit mode. Previous
settings are preserved.
Password
®
For the initial OnCue Plus setup, you will be required to reset the OnCue
®
into the OnCue Plus software. To reset the password, follow the instructions in the figure titled: Network Status Submenu.
Note:
The password is displayed for only 10 seconds. Be sure to write down the password and serial number.
A new password is generated each time the reset password procedure is performed. If the password is reset after the OnCue
Plus system has been set up, the connection will be lost. Enter the new password in OnCue
Networking--->
Information
Figure 34 Network Configuration Submenu
48
Networking--->
Status
Networking Reset OnCue
Configuration Password
®
password on the VSC controller, and then enter it
HOLD
DHCP:
Enabled
<--- Return
® ®
OnCue Plus Generator
®
Plus to reconnect.
Reset OnCue
Password? No
UP arrow for YES,
Down arrow for NO.
Reset OnCue
Password? Yes
Press Select to enter YES or
NO as displayed. New
password is displayed for
approximately 10 seconds.
S/N: 1234567
New PW: 12345
TP-6843
®
12/21