To Stop Scrubbing; Double Scrub - Windsor Chariot iScrub CSX24 Operating Instructions Manual

To Stop Scrubbing

1. Rotate the function knob to either transport posi-
tion. The brush motors will stop and the scrub deck
will rise to the park position. After 10 seconds the
squeegee will raise, and 10 seconds later the vac-
uum motor will turn off. This delay is to clear the
vacuum hose of recovered solution.
2. Allow the throttle pedal to return to neutral.
3. Turn machine power off.
FOR SAFETY: Before leaving or servicing
machine: stop on level surface, turn off machine
and remove key.

Double Scrub

For floors which are heavily soiled or have thick accu-
mulations of floor finish, may not clean sufficiently with
one pass. In these cases it will be necessary to double
scrub.
Rotate the knob to the double scrub position.
Make the first pass over the surface being cleaned with
the squeegee up, vacuum off and the solution on. For
best results also remove the Aqua-mizer™, this will
allow the solution to stay in contact with the soil while
loosening the surface accumulation with the brushes.
Allow time for the first application to stay in contact with
the floor. Length of time between the first and second
pass depends on amount of accumulation and the type
of chemical being used. A second scrubbing with the
function knob in one of the normal scrubbing modes will
lower the squeegee and will keep the solution on and
brushes down to further loosen soil. The additional
application of solution will further assist the difficult
cleaning job.
FOR SAFETY: When using machine, go slow on
inclines and slippery services
86317500 CHARIOT SCRUBBER
Operations
23