Troubleshooting; Tank; Vacuum - Windsor Chariot iScrub CSX24 Operating Instructions Manual

Troubleshooting

PROBLEM
No power to machine
Little or no propel
Machine does not
change speeds
Forward speed only
Reverse speed only
Poor or no water pickup Squeegee out of adjustment
CAUSE
Battery disconnected
Emergency shut-off activated
Battery cables corroded
Faulty key switch
Low battery charge
Machine turned on with pedal not in neutral
position
Tripped circuit breaker
Wheels spin
Controller overheated
Loose motor connection
Faulty throttle circuit or potentiometer
Faulty drive reset circuit or switch
Faulty platform circuit or switch
Brake over-ride engaged
Faulty brake circuit or over-ride switch
Faulty speed control circuit or switch
Faulty forward/reverse circuit
Debris caught on squeegee
Worn squeegee blades
Vacuum hose clogged
Vacuum hose disconnected from squeegee
or recovery tank dome
Recovery tank float system dirty
Recovery tank not sealed
Float-ball shut-off engaged Tank full
Foam filling recovery tank
86317500 CHARIOT SCRUBBER
Maintenance
SOLUTION
Check all battery cable connections
Reset
Clean connections
Replace switch
Charge batteries
Allow pedal to return to neutral. Restart.
Reset circuit breaker
Decrease brush pressure
Allow cool down period
Check wires and connections from
controller to motor
Check wires and connections from and
potentiometer resistance
Check wires, connections and switch
Check wires, connections and switch
Disengage brake over-ride
Check wires, connections and switch
Check wires & connections
Check wires & connections
Adjust squeegee
Remove debris
Rotate or replace squeegee blades
Clear obstruction from hose
Reconnect vacuum hose
Clean float system
Place recovery tank dome on tank.
Replace damaged gaskets
Empty recovery tank
Empty recovery tank. Use less or different
detergent. Use defoamer.
51