Maintenance; Scrub Brushes; Finished Floors; Replacing Or Installing Scrub Brushes (Disk) - Windsor Chariot iScrub CSX24 Operating Instructions Manual

Maintenance

Scrub Brushes

There are four different types of brushes available to
cover applications from cleaning heavily soiled floors to
polishing. A pad driver is also available to take
advantage of the many cleaning pads on the market.
Please refer to the following to assist in selecting the
proper brush or pad for the work at hand.
Uncoated Floors
Aggressive Grit is a nylon fiber impregnated with
silicone carbide grit. It grinds away stain, soil, and
removes surface material.
Mild Grit is a less aggressive silicone carbide grit
suitable for cleaning medium soil conditions. Advan-
tages are faster ground speed than nylon bristles on
light solid applications.
Polypropylene is a general-purpose scrub brush with
stiff bristles. Polypropylene works well for maintaining
concrete, wood and tile floors.

Finished Floors

Nylon bristles are used in a variety of applications on
coated or uncoated surfaces.
White Pads (Polishing) are used for dry polishing to
achieve a high-gloss appearance, or surface washing
on highly polished or burnished floors.
Red Pads (Buffing) are used for light-duty scrubbing.
When used with a mild detergent they will provide
surface cleaning without removing the finsh.
Blue Pads (Scrubbing) are used for heavy-duty
scrubbing and light stripping. The blue pads remove
less finish than brown stripping pads, yet will remove
black marks, stains and dirt.
Black Pads (Stripping) are used for easy and complete
removal of old floor waxes/finishes. They will quickly
remove ground in dirt, black heel marks, and spills.
When used with the proper stripper, this pad leaves the
floor clean and ready for finishing.
The scrub brushes should be checked before each
days work for wire, string, wear and damage.
34
Replacing or Installing Scrub Brushes
(Disk)
1. Turn machine function dial to transport mode,
allowing deck to return to "up" position. Turn the
machine power off.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF machine and
remove key.
2. Remove scrub deck skirts on left and right sides by
lifting directly up and pulling out.
3. Locate release lever on top of brush or pad driver.
Rotate release lever counterclockwise and the
brush/pad driver will release and drop down.
4. To reinstall, center the brush/pad driver under the
brush drive hub. Raise it until it contacts brush
driver assembly. Turn clockwise until release lever
plate locks into position.
5. Replace scrub deck skirts on both sides.
NOTE: Check that release lever/plate is completely
closed and pad/brush is securely attached. Damage
to driver or brush could occur if not securely attached.
Replacing or Installing Scrub Brushes
(Cylindrical)
1. Turn machine function dial to transport mode,
allowing deck to return to "up" position. Turn the
machine power off.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF machine and
remove key.
2. On right and left sides of deck, turn both brush and
skirt releases 1/4 turn counter-clockwise.
3. Swing deck skirts out. Remove brush end caps.
Slide brushes out the sides of deck.
4. To reinstall, slide brushes into deck. Replace brush
end caps. Lift end cap up and turn brush release
1/4 turn clockwise, locking brush in place. Swing
deck skirt back to deck. Turn skirt release 1/4 turn
clockwise, locking skirt into place.
NOTE: Check that brush end cap is properly secured
into deck housing. Check that brush is suspended off
ground while deck is in "up" position.
86317500 CHARIOT SCRUBBER