To Stop Scrubbing; Double Scrub - Windsor chariot iSCRUB CS24 10060210 Operating Instructions Manual

TO STOP SCRUBBING

1. BASIC AND CYLINDRICAL
Raise the scrub deck, turn off scrub
brushes.
Raise squeegee, turn off vacuum.
DELUXE
Press the one-touch switch (#1) on the
control panel. The brush motors will stop
and the scrub deck will rise to the park
position. After 15 seconds the squeegee
will raise, and 15 seconds later the vacuum
motor will turn off. This delay is to clear the
vacuum hose of recovered solution.
2. Allow the throttle pedal to return to neutral.
3. Turn machine power off.
FOR SAFETY: Before leaving or servicing
machine: stop on level surface, turn off machine
and remove key.

DOUBLE SCRUB

For floors which are heavily soiled or have thick
accumulations of floor finish may not clean
sufficiently with one pass. In these cases it will be
necessary to double scrub.
To double scrub, make the first pass over the
surface being cleaned with the squeegee up,
vacuum off, the solution on, Aqua-Mizer removed
and brushes down. This allows the solution to stay in
contact with the soil while loosening the surface
accumulation with the brushes. Allow time for the
first application to stay in contact with the floor.
Length of time between the first and second pass
depends on amount of accumulation and the type of
chemical being used. A second scrubbing with the
squeegee down and again the solution and brushes
on will further loosen soil. The additional application
of solution will further assist the difficult cleaning job.
FOR SAFETY: When using machine, go slow on
inclines and slippery services.
86037660 CHARIOT 11/09/06
MACHINE OPERATION
3-18