To Begin Scrubbing; To Stop Scrubbing; Double Scrub - Windsor Chariot 3 iScrub 26 CS26 Operating Instructions Manual

Operations

To Begin Scrubbing

When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
Lorsque vous utilisez la machine en présence de
gens, portez une attention particulière aux mouve-
ments inattendus. Soyez plus prudent, surtout en
présence d'enfants.
Flammable liquids and/or reactive metals can
cause explosions or fire! Do not pick up.
Les liquides inflammables et / ou les métaux
réactifs peuvent provoquer des explosions ou un
incendie! Ne les ramassez pas.
1. Stand on the operator platform. Throttle pedal
must be in neutral position.
2. Turn machine power on.
3. Press the Drive Reset / Directional Control Switch,
selecting the desired travel direction.
4. Position the function control knob to the desired
operation. The scrub deck and squeegee will
lower, and the vacuum will turn on.
5. Drive machine forward to begin scrubbing. The
scrub brush motors will run and solution will flow
when the throttle is depressed.
NOTE: Shut machine off immediately if water or foam
is expelled from the machine.
NOTE: Solution flow is automatically shut off when
brush motors stop. When brush motors are
activated, flow automatically resumes.
22

To Stop Scrubbing

1. Rotate the function knob to either transport posi-
2. Allow the throttle pedal to return to neutral.
3. Turn machine power off.

Double Scrub

For floors which are heavily soiled or have thick accu-
mulations of floor finish, may not clean sufficiently with
one pass. In these cases it may be necessary to double
scrub.
Rotate the knob to the double scrub position.
Make the first pass over the surface being cleaned with
the squeegee up, vacuum off and the solution on. For
best results also remove the Aqua-mizer™, this will
allow the solution to stay in contact with the soil while
loosening the surface accumulation with the brushes.
Allow time for the first application to stay in contact with
the floor. Length of time between the first and second
pass depends on amount of accumulation and the type
of chemical being used. A second scrubbing with the
function knob in one of the normal scrubbing modes will
lower the squeegee and will keep the solution on and
86395370 Operator Manual - Chariot 3 iScrub 26
NOTE: The solution flow can be adjusted up or down
approximately 10 percent by changing the dip switch
settings on the control board. The dip switches are
located on the left side of the control board, mounted
on the lower control panel.
NOMINAL + 20%
2
1 1
OFF OFF ON
tion. The brush motors will stop and the scrub deck
will rise to the park position. After 10 seconds the
squeegee will raise, and 10 seconds later the vac-
uum motor will turn off. This delay is to clear the
vacuum hose of recovered solution.
FOR SAFETY: Before leaving or servicing
machine: stop on level surface, turn off machine
and remove key.
- 20%
2 2
1
OFF OFF ON