To Begin Scrubbing; To Stop Scrubbing; Double Scrub - Windsor SC20 10052190 Operating Instructions Manual

Operations

To Begin Scrubbing

When operating the machine around people, pay
close attention for unexpected movement. Use
extra caution around children.
Lorsque vous utilisez la machine en présence de
gens, portez une attention particulière aux mouve-
ments inattendus. Soyez plus prudent, surtout en
présence d'enfants.
Flammable liquids and/or reactive metals can
cause explosions or fire! Do not pick up.
Les liquides inflammables et / ou les métaux
réactifs peuvent provoquer des explosions ou un
incendie ! Ne les ramassez pas.
1. Turn the machine power on.
2. Lower the squeegee.
3. Turn the vacuum on.
4. Lower the scrub brush to the floor.
5. Turn the scrub brush on (for traction model, brush
will start when machine is propelled).
6. Drive machine forward to begin scrubbing.
NOTE: Shut machine off immediately if water or
foam is expelled from the machine.
7. Adjust the speed of the machine, solution flow and
scrub brush pressure as necessary.
NOTE: For non-traction model, the solution flow must
be shut off to prevent unintentional draining of
solution tank. For traction model, once solution flow
rate is set it is not necessary to shut off solution when
stopping scrubbing. Solution flow is automatically
shut off when the brush motor stops. When the brush
motor is activated, flow will automatically resume.
20

To Stop Scrubbing

1. Release the directional control button(s), if your
2. Turn the scrub brush off.
3. Raise the scrub brush.
4. Raise the squeegee.
5. Turn the vacuum off.
6. Turn the machine power off.

Double Scrub

For floors which are heavily soiled or have thick accu-
mulations of floor finish the machine may not clean
sufficiently with one pass. In these cases it will be
necessary to double scrub.
To double scrub, make the first pass over the surface
being cleaned with the squeegee up, vacuum off, the
solution on, and brush down and on. This allows the
solution to stay in contact with the soil while loosening
the surface accumulation with the brush. Allow time for
the first application to stay in contact with the floor. The
length of time between the first and second pass
depends on the amount of accumulation and the type of
chemical being used. A second scrubbing with the
squeegee down, vacuum on and again with solution
and brush on will further loosen the soil. The additional
application of solution will further assist the difficult
cleaning job.
86400640 Operator's Manual - Saber Compact 20
machine is traction model.
When using machine, go slow on
FOR SAFETY:
inclines and slippery services.