Remote Panic Feature - Omega Excalibur AL-1000-E Owner's Manual

ignition key "on". Also, Automatic Rearming can be cancelled by the Safety Disarm/Storm Mode
feature; if the system is disarmed while triggered, Automatic Rearming will not occur. Automatic
Rearming is confirmed by a fast flashing Status Light after disarming, unless the system was triggered,
in which case a Zone Violation code will flash instead.
Disarming the System by Emergency Override
Should the transmitter become lost, damaged, or its batteries become exhausted, the Valet Switch
and the vehicle's ignition key may be used to disarm the system:
Step 1 With the system in the armed condition, enter the vehicle via the driver's door (be aware that
the system will activate to an alarm condition when the door is opened).
Step 2 Using the ignition key, turn the vehicle's ignition switch on.
Step 3 Within 5 seconds press and release the Valet Switch one time. The system will disarm.
The number of Valet Switch presses which are required for the Emergency Override is custom-
programmable! This is the SecureCode feature, which is described on page 14. The above
Emergency Override instructions reflect the "as received from the factory" default setting.

Remote Panic Feature

Should you feel threatened, or the need to attract attention, you can activate your system's remote
"Panic" feature at any time by pressing and holding for 3 seconds any of these three transmitter buttons:
"arm/lock", "disarm/unlock" or the red "III" button. Your system will respond by sounding the siren
and flashing the parking lights for the normal activated alarm period of 30 seconds. Further, the
Excalibur system features an unique "enhanced" remote Panic operation, regarding additional
Page - 11