Programmable Features - Omega Excalibur AL-1000-E Owner's Manual

Feature #1 SecureCode
SecureCode is a unique patented feature which allows you to custom select the number of Valet Switch
presses in two stages, instead of a single "1 press", which would be required in order to perform an
Emergency Override. If any of the three anti-carjacking features are utilized, a customized SecureCode
would also be required to turn it off once it is fully activated. The SecureCode operation is described
on page 14.
To custom program a new SecureCode:
Step 1 Follow Steps 1 to 4 in the previous "How to Program Features" instructions; at Step 4 the
Valet Switch will be pressed and released once (the siren chirps once) to access "feature #1".
Step 2 Within 10 seconds slowly press and release the transmitter's "arm/lock" button the number
of times equal to the desired SecureCode for stage 1, allow the system to respond to each
transmitter button press with a siren chirp before pressing the button again.
Step 3 After entering the first stage by pressing the transmitter "arm/lock" button the desired
number of times, and receiving a chirp for each press, wait for the system, after the final
button press, to chirp the siren again the total number of times that the button was pressed.
Step 4 Continue to configure stage 2 of the SecureCode by now pressing and releasing the "disarm/
unlock" button the number of times desired for the stage 2. This should be done in the exact
same fashion as the stage 1 entry- press the "disarm/unlock" button, wait for a single chirp
before pressing the button again, and then when final button press is done, wait after the
single chirp for the siren to chirp the total number entered Valet switch entry.
The Programmable Features
(Factory Default Setting 1 Press)
Page - 25