Chapter 10
Switch Configuration
In order to...
Access Layer 3 configuration if not
logged in as supervisor (see
"Entering the Supervisor Level" on
page 37)
System Parameter Configuration
Identifying the system
In order to make a P330 switch easier to identify, you can define a name for the
switch, contact information for the switch technician, and the location of the switch
in the organization. The rules of syntax and output examples are all set out in detail
in the Reference Guide.
In order to...
Configure the system name.
Configure the system contact
person
Configure the system location
Operating parameters
You can use the following commands to configure and display the mode of
operation for the switch and display key parameters. The rules of syntax and output
examples are all set out in detail in the Reference Guide.
In order to...
Configure the basic mode of
operation of a module to either
Layer 2 or Router
Display the mode of operation
Display system parameters
Display module information for all
modules within the stack
62
Use the following command...
configure
Use the following command...
set system name
set system contact
set system location
Use the following command...
set device-mode
show device-mode
show system
show module
Avaya P334T-ML User's Guide