Qos Option Setting - Avaya 4600 Series Installation Manual

8. Press the 1 or 0 button to turn 802.1Q on or off respectively.
The display is updated to show the current status of 802.1Q.
Press the # button to continue the procedure without changing the displayed status of 802.1Q
The following text is displayed left-justified at the top of the display:
VLAN ID=dddd
New=_
where dddd is the value of the 802.1 VLAN ID.
9. Enter a valid value (between 0 and 4095) for the new value of the 802.1 VLAN ID.
The following message is displayed:
Save new values?
*=no #=yes
10. Press the # button to save the new values you have entered.
The following message is displayed:
New values
being saved
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the TFTP server after you enter static addressing
information, you will need to reenter your static addressing information.

QOS Option Setting

Administering QOS options is not mandatory, but it is highly recommended.
Use the following procedure to set Quality of Service (QOS) options.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate of
the telephone:
Mute 7 6 7 # (Mute Q O S #)
Press the Mute button momentarily. Do not press this button while pressing other keys/
buttons. The 4630 IP Telephone does not have a dedicated Hold button; for all other
4600 Series IP Telephones, pressing the Hold button instead of the Mute button will also
work.
The following text is displayed left-justified at the top of the display:
L2 audio=d
New=_
where d is the value of the 802.1 audio parameter.
Chapter 3: Local Administrative Options
3
Static Addressing Installation
3-5