Removing A Hard Disk Drive From The Hard Drive Bay - HP Z600 Maintenance And Service Manual

Removing a hard disk drive from the hard drive bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Press the green hard disk drive release tab
the hard disk drive from the chassis as shown in the following figure.
Figure 5-36
4. Carefully separate the upper hard disk drive carrier rails,
shown in the following figure.
Figure 5-37
Carefully separate the lower carrier rails
5. Reinstall all removed components and reconnect all cables that have been disconnected.
ENWW
Removing the drive from the chassis
Removing the drive from the carrier
Predisassembly procedures on page
Removing the side access panel on page
, lift the handle
, and then remove the drive from the carrier.
Removing and installing components 103
75).
, and then use the handle to pull
2
and then tilt the drive outward
73).
as
2