Removing A 2.5-Inch Hard Drive; Installing A 2.5-Inch Hard Drive - HP ProDesk 600 Maintenance And Service Manual

Removing a 2.5-inch hard drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Rotate the drive cage to its upright position.
4. Disconnect the power cable and data cable from the back of the hard drive.
5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops
and pull it down and out of the drive bay (2).

Installing a 2.5-inch hard drive

1.
Prepare the computer for disassembly
2.
If the computer is on a stand, remove the computer from the stand.
3.
Remove the access panel
110 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
(Preparation for disassembly on page
(Access panel on page
(Preparation for disassembly on page
(Access panel on page
86).
86).
85).
85).