HP ProDesk 600 Maintenance And Service Manual page 138

5. Rotate the locking lever to its full open position (1).
6. Raise and rotate the microprocessor retainer to its fully open position (2).
7. Carefully lift the processor from the socket (3).
CAUTION:
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to
the processor's solder connections.
NOTE: After installing a new processor onto the system board, always update the system ROM to
ensure that the latest version of the BIOS is being used on the computer. The latest system BIOS can be
found on the Web at: http://www8.hp.com/us/en/support-drivers.html.
128 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)
Do NOT handle the pins in the processor socket. These pins are very fragile and