Installing A 3.5-Inch Device - HP ProDesk 600 Maintenance And Service Manual

Installing a 3.5-inch device

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
drive in a bay covered by a bezel blank, remove the bezel blank. See
on page 50
4. Install 6-32 guide screws in the holes on each side of the drive.
NOTE:
on page 51
When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.
5.
Slide the drive into the drive bay, making sure to align the guide screws with the guide slots, until
the drive snaps into place.
58 Chapter 5 Removal and replacement procedures: Tower (TWR)
(Access panel on page
(Front bezel on page
for more information.
HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to
for an illustration of the extra guide screws location.
(Preparation for disassembly on page
38).
40). Remove the front bezel. If you are installing a
37).
System board connections
Drives